i soldered the red wire
and i dunno if i should solder the blue one to the pin, cuz it was really risky, so i just wrapped the exposed wire around the 14th pin leg instead
the white magetic power strip thing that you plug into the chip has a really sticky, blue plastic tape on it that i didn't notice in your pics on the site racketboy, but i think it should be ok. so i plugged that into the chip and plugged the chip in.........and no luck, just says check format.
i think its cuz the chips not all the way in, i mean i can still see the connectors, but damn i can't push it all the way in even if i push really hard, hard enough that the white socket hole thing bends! i heard that i can sand it down, but wouldn't that damage the connectors?!
and also, i can't remove the chip from the sytstem now cuz the red wire's already soldered in place.
