Genesis Problem - Sonic Keeps looking up

SMS, Genesis, 32X, Sega CD, Saturn, Dreamcast
User avatar
ProfessorK
64-bit
Posts: 358
Joined: Mon Dec 28, 2009 11:02 am
Location: Fulton, NY

Re: Genesis Problem - Sonic Keeps looking up

Post by ProfessorK »

Ziggy587 wrote:Oh, sorry. I read this late last night, I didn't realize in the first post you said you already exchanged the controller for another one and still have the same problem.

I know you said you checked the controller port pins and that they weren't bent. But take a look at them again and see if they look like the might be corroded or real dirty. Put a flash light on them if needed.
They look shiny and silver. I cleaned them out anyway, but it didn't change anything.
Image
User avatar
KDub
Next-Gen
Posts: 1646
Joined: Fri Aug 06, 2010 11:47 pm
Location: St. Louis, MO
Contact:

Re: Genesis Problem - Sonic Keeps looking up

Post by KDub »

It could be the connectors on the inside, I've seen it before. Spill some soda or water on the system and clean it up but all that leaked down in there was left. All these years later and you have a clean system outside but several pins rusted out on the inside.
User avatar
ProfessorK
64-bit
Posts: 358
Joined: Mon Dec 28, 2009 11:02 am
Location: Fulton, NY

Re: Genesis Problem - Sonic Keeps looking up

Post by ProfessorK »

KDub wrote:It could be the connectors on the inside, I've seen it before. Spill some soda or water on the system and clean it up but all that leaked down in there was left. All these years later and you have a clean system outside but several pins rusted out on the inside.
I've been thinking that too. I saw on a different site that the solder points on the board get weakened over the years and can cause problems like this. I tried opening the console but one of the screws on the heat shield is stripped and I can't get it off.

I'm going to bring it back to the store I got it from tomorrow. See what they want to do about it. I know they'll replace the console, it's just kind of a shame. Everything else about this one is perfect.
Image
User avatar
Ziggy
Moderator
Posts: 14913
Joined: Mon Jun 09, 2008 5:12 pm
Location: NY

Re: Genesis Problem - Sonic Keeps looking up

Post by Ziggy »

For stripped philipshead screws, you can usually use the right size flat head to get them out.
User avatar
ProfessorK
64-bit
Posts: 358
Joined: Mon Dec 28, 2009 11:02 am
Location: Fulton, NY

Re: Genesis Problem - Sonic Keeps looking up

Post by ProfessorK »

I ended up taking it back to the store and they replaced it with one that works fine. It definitely wasn't the controllers because they are both working great now. I assume it was the connections on the board, but without a soldering iron I couldn't do anything about that anyway.

Thanks for the suggestions, everyone. :D
Image
Post Reply