Removing Dreamcast logo from lid

[sd_dracula]

Hi.
I have taken my Dreamcast apart for a repaint as it started to get yellow and I am just unsure how to take off the Dreamcast logo from the centre of the lid.
Have tried getting a stanley knife under it but there is not enough room

Does any one know of a trick to safely remove that sticker and also that bit of plastic that sits right above the power LED?

[SpoonyBard]

Doesn't really answer your question, but I figured i'd throw this out there in case you weren't familiar with it.

http://retr0bright.wikispaces.com/

[Hobie-wan]

You might be able to use some goo gone or something dribbled around them and left to soak so the glue softens up.

[miked]

Hmm I sprayed one a few years ago and the logo came off easily with an thin box cutter blade. A dab of super glue after it was dried and back on it went.

[sd_dracula]

Hmm I sprayed one a few years ago and the logo came off easily with an thin box cutter blade. A dab of super glue after it was dried and back on it went.

Success in the logo but the lower part won't come out with the box cutter.

[Ziggy]

Just tape it.

[samsonlonghair]

Masking tape, brother, masking tape.

[sd_dracula]

Masking tape, brother, masking tape.

Cool. Will do. Thanks

[Ziggy]

Painter's tape is usually better to use, but masking tape will do you fine. 3M's ScotchBlue painting tape is great, but a little expensive.

[xxstatic]

Taped mine.