Original Xbox Modchips - Need advice

Gaming on the Playstation and Xbox Platforms
Post Reply
User avatar
Satoshi_Matrix
Next-Gen
Posts: 1340
Joined: Tue Jun 08, 2010 3:51 pm
Location: Ontario Canada
Contact:

Original Xbox Modchips - Need advice

Post by Satoshi_Matrix »

I have a bit of an odd situation that I need some help with. I have a Xbox 1.6 that I've been using for years. It has an Aladdin XenoFX Modchip and massive 750 GB IDE harddrive installed.

Unfortunately, I seem to have blown some surface mounted fuse that controls the fan. To get the fan spinning, I stole power from the harddrive, which means the fan runs at 100% speed at all given times.

I have another xbox, a 1.4 that's been softmodded and still has its stock 8GB HDD. I would like to make that Xbox my main system by transferring over the huge 750 GB harddrive.

So what's the best solution now in 2012? Should I go with a modchip? If so, which one? The only thing I care about is being able to access my entire 750 GB drive, even if I have to format it when I move it.

Any recommended programs or modchip names would be appreciated. Thanks.
Last edited by Satoshi_Matrix on Thu Apr 05, 2012 12:05 pm, edited 1 time in total.
User avatar
Cronozilla
Next-Gen
Posts: 2609
Joined: Wed Mar 14, 2012 8:15 pm
Location: Oregon, USA.

Re: Install 750 GB HDD in Original Xbox - Need advice

Post by Cronozilla »

Why don't you just replace the fuse? Even surface mounted ones aren't that hard to replace.
User avatar
Satoshi_Matrix
Next-Gen
Posts: 1340
Joined: Tue Jun 08, 2010 3:51 pm
Location: Ontario Canada
Contact:

Re: Install 750 GB HDD in Original Xbox - Need advice

Post by Satoshi_Matrix »

because the fuse in question is downright microscopic, and I'd also like to someday preform the 128MB RAM mod on my 1.4, impossible on the 1.6.

So basically my question is what is the best modchip to go with? I'm thinking of going with the DuoX-2 GS. Anyone have any thoughts?
gtmtnbiker
Next-Gen
Posts: 4320
Joined: Fri Jan 09, 2009 1:14 pm
Location: Massachusetts

Re: Install 750 GB HDD in Original Xbox - Need advice

Post by gtmtnbiker »

Satoshi_Matrix wrote: So basically my question is what is the best modchip to go with? I'm thinking of going with the DuoX-2 GS. Anyone have any thoughts?
That's the one I used. Works great. No issues.
User avatar
Satoshi_Matrix
Next-Gen
Posts: 1340
Joined: Tue Jun 08, 2010 3:51 pm
Location: Ontario Canada
Contact:

Re: Original Xbox Modchips - Need advice

Post by Satoshi_Matrix »

How difficult is it to install?

Is it solder in and then it just works?
gtmtnbiker
Next-Gen
Posts: 4320
Joined: Fri Jan 09, 2009 1:14 pm
Location: Massachusetts

Re: Original Xbox Modchips - Need advice

Post by gtmtnbiker »

It wasn't too bad. The d0 point was the toughest but I found an alternate point that was slightly easier but still, it was tough. The LPC header was easy other than desoldering/cleaning out the holes.
User avatar
jinn
128-bit
Posts: 569
Joined: Fri Jun 25, 2010 2:12 am
Location: California

Re: Original Xbox Modchips - Need advice

Post by jinn »

just TSOP flash the 1.4. all you need to do is solder 2 point together and if you can't solder you can always use this http://www.radioshack.com/product/index ... Id=3964901
Then use hexen disc to flash the TSOP with a 256kb BIOS.
PSone, Xbox, PS2, DC, SS Mod Service, PM for details
User avatar
Satoshi_Matrix
Next-Gen
Posts: 1340
Joined: Tue Jun 08, 2010 3:51 pm
Location: Ontario Canada
Contact:

Re: Original Xbox Modchips - Need advice

Post by Satoshi_Matrix »

I can solder pretty much anything. Can you give me some details? I'll pm you.
Post Reply