what size drill bit do I need to mount an s-video jack?

Post by **AppleQueso** » Thu Sep 22, 2011 2:23 pm

hopefully a really, really simple question

Post by **gtmtnbiker** » Thu Sep 22, 2011 3:19 pm

Why don't you take a ruler and just measure the jack?

Post by **Jamisonia** » Fri Sep 23, 2011 12:07 am

It depends on the jack. I use chassis mount ones.

Website · Post by **Hobie-wan** » Fri Sep 23, 2011 12:49 pm

Indeed, different jacks will be different. It will likely be around 5/16 or 3/8 which should be included in any halfway decent starter drill bit set. Just remember that you want to drill into plastic slowly. You want to cut it, not melt it.

Post by **Bikeage** » Fri Sep 23, 2011 11:35 pm

You may want to drill a smaller hole than you need and then use a circular file to get the correct diameter. This worked for me doing an S-video mod to a Genesis, gave me a nice snug fit.

what size drill bit do I need to mount an s-video jack?

what size drill bit do I need to mount an s-video jack?

Re: what size drill bit do I need to mount an s-video jack?

Re: what size drill bit do I need to mount an s-video jack?

Re: what size drill bit do I need to mount an s-video jack?

Re: what size drill bit do I need to mount an s-video jack?