Scratch remover?

[SGGG2]

Just got a Skeleton Saturn but the controllers have some noticable scratches

Does anyone have a recommendation?

[Scooter]

Just got a Skeleton Saturn but the controllers have some noticable scratches

Does anyone have a recommendation?

Deal with it?

Seriously, there's no way to remove the scratches without making the whole thing look even worse.

[Niode]

It depends on how deep the scratches are.

[CRTGAMER]

Lotsa sanding, little paint, buffing, and polishing. See what this guy did ...............
Racketboy post: http://www.racketboy.com/forum/viewtopi ... 25&t=18567

[Scooter]

I'm assuming a skeleton Saturn would have skeleton controllers. If that's the case, painting them would kind of negate the whole point of having skeleton pieces.

[Anapan]

You can use car polish on a lot of types of plastic, if you started at a rough grit cutting compound to get the scratches out and slowly went to 2000+ grit you could get back a mirror shine. It takes a lot of time or a good variable speed buffer tho. If you were to go the buffer route, you really have to watch out for heat as it'll cloud or melt the plastic in no-time. I tried it on a GBC screen with pretty deep scratches and a large scuff-mark, and was able to get all the scratches out after about 25 minutes, but after going to 1000 grit, I found I needed a finer polish to get the reflection back to mirror-like rather than small circles. Then I found the replacement case at deal-extreme and threw my old case away.

[CRTGAMER]

I'm assuming a skeleton Saturn would have skeleton controllers. If that's the case, painting them would kind of negate the whole point of having skeleton pieces.

But its a classic with the original factory paint!



Well okay then try to polish it out ................