ps2 sencer

[parker]

i have a problem with my ps2 sincer it came off its the one that is not on the power butten
is there any way to bypass this il upload a pic if needed

[Omerta]

Go ahead and post a pic. I can't think of what kind of sensor you're talking about off the top of my head.

[parker]

my camra is mest up so not my ps2 slim it the one from google

[Jmustang1968]

git yore camra fixt so we can sea a cloze upt of yoor pstoo slime boreed senzor

[parker]

[Omerta]

I haven't opened a PS2 slim, but I assume that's just a switch to detect if the lid is open.

What is it doing? Is it booting up the internal software but won't let you play discs?

If it is a sensor for the door and it's just a micro switch you could just use an ohm meter on it to determine if it's normally open or normally closed. Then either solder a jumper on the board or cut the trace so that it makes the PS2 think the door is always closed...

[CRTGAMER]

i have a problem with my ps2 sincer it came off its the one that is not on the power butten
is there any way to bypass this il upload a pic if needed

Your pics and words are both "blurry". Maybe spell check and clean up of your sentences before posting a Thread asking for help?

The pics are too up close to verify without a pulled back pic for comparison as to where the problem is. What exactly is wrong and how did it break? A senser/sincer tells us nothing.

As Omerta mentioned, I'm guessing you are talking about the door detection switch. Either solder in a new switch if you can find a replacement cheap or jumper the switch circuit. The problem of the jumper method is you have to insert a game before powering on and waiting until a disc stops before changing a game. At least a workable inexpensive fix though.

[parker]

its the sensor that gos to the door and i was trying to get the ps2 to think it was always closed and i put sticky tact ans win i try ed to get the tact off the sensor came with it and came right off also i need more detail on how to fix it can i just cut the the whole sensor part off?

[Omerta]

Yeah just figure out where to jumper the switch out or where the circuit needs broken and you should be good.

What were you trying to accomplish? Are you hot-swapping discs to play burned CDs or foreign games? I'd imagine it would have been easier to just wedge a piece of paper or something in it instead of sticky tact (tape?).