2 PS3's side by side....

[wclem]

So can I run two PS3's right next to each other in the same room on two different tvs? My concern is that the controllers will freak out. Has anyone tried this yet?

[fastbilly1]

They can run on different bluetooth stacks, it is not a problem. Just make sure you give each one enough breathing room.

[irixith]

Make sure you have adequate power available, especially if they're fat PS3s -- those consume just over 200W of power while playing a game. (A slim consumes just under 100W.) Coupled with your TVs and other a/v equipment, just a thought.

[CRTGAMER]

Make sure you have adequate power available, especially if they're fat PS3s -- those consume just over 200W of power while playing a game. (A slim consumes just under 100W.) Coupled with your TVs and other a/v equipment, just a thought.

THIS TO AVOID A YLOD
No cheap extension cords, direct plug each into the outlet. Even better get a fat 20 amp appliance extension cord and plug the second PS3 into another outlet on a different circuit.

[wclem]

cool, considering buying another as Netflix is monopolizing it.

[dsheinem]

Make sure you have adequate power available, especially if they're fat PS3s -- those consume just over 200W of power while playing a game. (A slim consumes just under 100W.) Coupled with your TVs and other a/v equipment, just a thought.

THIS TO AVOID A YLOD
No cheap extension cords, direct plug each into the outlet. Even better get a fat 20 amp appliance extension cord and plug the second PS3 into another outlet on a different circuit.

Wait, how does plugging directly into a wall lower the risk of YLOD? I am pretty sure power bars work just fine...can you link to some hard evidence? It's not like we're plugging in dryers or stoves...

[jeffro11]

Electrician here!

That wont cause YLOD. But if your powerbar is rated less then 15 Amps. The cable will heat up and potentially burn if you overdraw the rated amperage (Not likely you'll be pulling anywhere near 15A). The 20A extension cord recommendation is not needed as your wall outlets will only provide 15A. You magical wattage limit is 1440watts (actually 12A) PER 15A circuit breaker. This is due to the fact we de-rate everything by 20% for safety.

[Hobie-wan]

Wait, how does plugging directly into a wall lower the risk of YLOD? I am pretty sure power bars work just fine...can you link to some hard evidence? It's not like we're plugging in dryers or stoves...

Indeed. Unless you're trying to run 2 giant TVs and all your consoles at the same time, PCs have been able to pull several hundred watts, plus an old CRT and maybe a laser printer with its heater all from the same power strip in one plug with no issues. Yes you dont' want to overload it, but unless you're living somewhere with aluminum wiring or running several TVs, consoles, and a bunch of arcade machines off the same circuit while someone dries their hair it will probably be fine. Circuit breakers have amp ratings for a reason.

[dsheinem]

Electrician here!

That wont cause YLOD. But if your powerbar is rated less then 15 Amps. The cable will heat up and potentially burn if you overdraw the rated amperage (Not likely you'll be pulling anywhere near 15A). The 20A extension cord recommendation is not needed as your wall outlets will only provide 15A. You magical wattage limit is 1440watts (actually 12A) PER 15A circuit breaker. This is due to the fact we de-rate everything by 20% for safety.

Thanks. Thought it sounded like bunk.

[CRTGAMER]

Chance of motor overheat if the source does not carry enough amperage
I have seen welders and compressors burn up due to low rated extension cords, the same cord can still run a drill just fine. With too much resistance the Alternating Current spikes and surges is not a good thing. The PS3 doesn't draw near as much juice but still a power hog with internal electric motors that needs an adequate supply. A 15 amp cord plugged into a 15 amp power strip which in turn is plugged into a 15 amp wall socket is not a guaranteed the full 15 amp availability.

All the stuff
irixith brought up a good point of other devices plugged in such as the HD that also draw power. You have to also have to consider ALL the devices that are plugged in a given circuit. The overhead light in the other bedroom for instance could also be pulling from the same circuit. All reducing available watts to the console, so why risk adding resistance thru a cheap extension cord or power strip?

There are two ratings to go by
Continuous watt draw and the more important SURGE amp rating from powering on a device. Usually double of the Watts/Amps printed on the sticker.