Ps1 screen
ps2 scph 70000 series
2 64mb memory cards
some epoxy
3 grits of sand paper 60, 100, 200 and found some 600 in my garage
Wire
8.4v 7900 mah battery
Everyone knows the lazer doodle. I had decided to use this to house my mobo with all of the goodies inside
. (I used hailrazers pic of the Lazer Doodle since I forgot to take a picture of mine)
First I started by cutting out the spot where the controller will be placed and then put some epoxy on the top to hold it in.
After letting it dry I went ahead and plastered the whole thing with some sand-able locktight putty and also reinforced the back almost using a whole 6 inch tube!
I then grabbed the 60 grit and did some rough sanding, two hours later I had this.
I then did a very light coat of white primer to check the flaws.
After doing this quite a few times using the 4 types of sand paper including the 200 and 600 for where the epoxy meets the abs plastic, I filled the "low spots" and waited for it to dry.
After getting the controller part done it was all a matter of finding the best way to put the screen in. So I put it over the lazer doodle and made a circle around it so that I can make a rough cut.
I then made a horribly looking cut. Remember as long as you sand it you will have no problem with cutting yourself on your case and yes... I did that.
To keep it together I bridged the gap with a little bit of lock-tight putty. Only using a little so if I change my mind I can easily fix that.
Doing like I did to the controller I plastered the whole thing with epoxy! And added some plastic fuser to the back.
I reinforced the back just like before and sanded just like I did to the controller earlier.
After all of the sanding was done I sprayed it with a few coats of primer to fill some hairline spots.
I then painted the whole thing a Krylon semi-gloss white! And after that sprayed it with some Rust-Oleum 2x enamel so that it will be shiny and fingerprints will not show up on it.
I have the back done and most of the wiring done aswell. The only thing I need to finish is a new ps1 screen (the one I have has a scratch on it and it bothers me). So if you want it for a commission let me know PM me! I will update you guys when I upload some more pictures
.
