Running the wrong voltage
-
terrybogard
- 32-bit
- Posts: 270
- Joined: Wed Aug 26, 2009 10:46 am
Running the wrong voltage
I have a PSOne that requires a 7.5v adapter. I plugged in a sega 10v that had the same polarity and MA. It didnt even budge a little. No cracking or power of anykind. I got the PSOne for 5.00 loose and figured id see what happens. Should i even bother getting the right adapter for the PSOne or do you think it never worked to begin with or i fried it. Like i said i see no life from this thing good or bad...

Re: Running the wrong voltage
for the long run, I would always run the voltage it recommends.
My brother plugged in a different adapter once for his portable DVD and it fried.
My brother plugged in a different adapter once for his portable DVD and it fried.
-
terrybogard
- 32-bit
- Posts: 270
- Joined: Wed Aug 26, 2009 10:46 am
Re: Running the wrong voltage
i know but i didnt have the right one. And it shows no life. It didnt sizzle or anything. Does anyone know if the voltage is to high is it possible for it to just not turn on but not be fried. do u think if i get the right ac adapter it will turn on. Or since it showed no life when i plugged in a higher voltage it didnt work to being with....

-
opticledilusi0n
- 32-bit
- Posts: 204
- Joined: Wed Dec 05, 2007 2:15 pm
- Location: dirty jersey
Re: Running the wrong voltage
option B is you fried it when using the 10v supply and now it's dead for good.
not hearing a sizzle or pop, doesn't mean you didn't damage anything.
but anyways, try the right voltage... maybe it will work
most dc electronics do have voltage regulators which try to affix the voltage to a constant rate sometimes you can use a supply very close to the voltage required and get away with it as the internal regulator would be able to drop it down to 7.5v
usually the regulators work within a few percent though and they all have an absolute maximum rating (at which point they will fail)
not hearing a sizzle or pop, doesn't mean you didn't damage anything.
but anyways, try the right voltage... maybe it will work
most dc electronics do have voltage regulators which try to affix the voltage to a constant rate sometimes you can use a supply very close to the voltage required and get away with it as the internal regulator would be able to drop it down to 7.5v
usually the regulators work within a few percent though and they all have an absolute maximum rating (at which point they will fail)
-
terrybogard
- 32-bit
- Posts: 270
- Joined: Wed Aug 26, 2009 10:46 am
Re: Running the wrong voltage
u dont know where i can find that supply for cheap. i got the system for 5 dollars as is at a pawn shop ironiclly in jersey.

Re: Running the wrong voltage
The PsOne works fine up to 12v. It runs to a regulator inside.
I would say the power supply you used just didn't make a good connection or is fluxed.
Get the proper power supply and it should work. Or at worst the fuse inside is blown and needs to be bridged.
I would say the power supply you used just didn't make a good connection or is fluxed.
Get the proper power supply and it should work. Or at worst the fuse inside is blown and needs to be bridged.
My Portable Systems:

-----Genimini---------Darth64---------Dreamtrooper--------Ncube---------Kamikazi64---N64Boy Advance
-----Genimini---------Darth64---------Dreamtrooper--------Ncube---------Kamikazi64---N64Boy Advance
-
darthbluntedone
- 16-bit
- Posts: 91
- Joined: Mon Jan 04, 2010 8:29 am
Re: Running the wrong voltage
hmmmmmironiclly in jersey
- Metalcrack
- 32-bit
- Posts: 220
- Joined: Thu Nov 15, 2007 4:50 pm
- Location: NE Ohio
Re: Running the wrong voltage
Do you have a multimeter? If so check the power supply. If not, check a few buddies, relatives, or even for an electronic shop nearby.
Atari2600/Colecovision/Dreamcast/DS-Lite/GBA/NES/N64/Gamecube/Saturn/Master System/Genesis-32X-CD/PS1/PS2/PSP/TG16/Xbox/Xbox 360/
Budget Gaming PC: .... AMD Phenom II x3 720, 6870 1GB, 4GB 1600 Ram
Budget Gaming PC: .... AMD Phenom II x3 720, 6870 1GB, 4GB 1600 Ram