Desperately don't want to waste my whole night, HELP Saturn

Post by **vanhalendlrband** » Sat May 19, 2007 11:49 pm

My saturn (which i believe is to be a sanyo drive) its got all the metal casing on the bottom. I have been trying for the life of me to find the sensor that i've seen in the pictures, but those saturns look different than mine and i can't find a sensor anywhere. I see no lever anywhere other than the drive door lock. I've been searching and reading all day and its just really getting hard to not just ask a question in these forums, so please forgive my newbieness.

Where do i tape for the swap trick. Its the Saturn where all beside the drive is metal casing, all the motherboard is under the metal casing it looks like.

Whoever can help me is gonna make me smile for the next week.

Whoops forgot to mention that this is to do with taping the sensor in the swap trick.

Post by **racketboy** » Sun May 20, 2007 9:02 am

Hmmm never done a swap on a Sanyo...
Anybody else?

Post by **Espio 1919** » Sun May 20, 2007 2:43 pm

hmmm...I had a similar problem when I was looking for the lever inside my Model 1. Tell me, do some of the wires on the Sanyo Saturn run along the top part of the Saturn's shell? If so then the lever that you need to tape down is in and around the disc door, I think the side opposite the gear that is attached to the door.